| WindPowerForums.com https://windenergy7.com/forums/ |
|
| Wire Sizing, Guage for Turbine Charge Controller to Battery https://windenergy7.com/forums/viewtopic.php?t=60 |
Page 1 of 1 |
| Author: | klh72055 [ Fri May 15, 2009 7:49 am ] |
| Post subject: | Wire Sizing, Guage for Turbine Charge Controller to Battery |
Off of the charge controller and the battery bank what is the wire sizing that is needed for them to hook up. Regular battery cable or size 8 AWG or "8 Guage" like the rest of the system. etc. curious |
|
| Author: | Rooftop Wind Turbine [ Sun May 17, 2009 3:21 pm ] |
| Post subject: | Wire Sizing From Controller to Battery |
Sorry I have not already replied to this. I am too busy this weekend to do it justice and provide a FULL answer. I will make a very brief reply that ( IT DEPENDS ). It depends on factors of amps of current, volts of current, and distance of the connection. Add to that, there is a reason that I wire with heavier guage usually than what would be required. Acceptable guidelines usually go with a wiring that allows 5% of the power to be lost to resistance. Five percent is normally acceptable in low voltage systems, but I like to wire for a 2% figure and I divide the normal distances that a wire would carry, beefing it up. Usually that is divided by 2 to 2.5. Of course, I will think of cost also. Example, on my battery bank, I use beefy welding cable at 1 or 2 guage. I could use less beefy, save money, but over time my system does better efficiency with the heavy cable. The wiring I use from controller to battery bank is always stranded and I use from 6 to 8 guage depending on what size turbine and how much solar, the length etc. Most people are using 8 guage there. -- turbineZ -- turbine@windenergy7.com . |
|
| Page 1 of 1 | All times are UTC-05:00 |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|