Wind Turbine Controller, Charge Controller

Please Verify This Is Same As Your Model, If Not Same, DO NOT depend on these settings, connections, or information. You must use the info specific to your model of turbine charge controller.

Turbine Controller Operation and Instructions
1. Shift the brake/release switch on front panel to “STOP” position.
2. Open the top cover of controller by removing the screws as shown:
3. Connect the wind generator 3 phase AC output to “WIND” terminal.
4. Connect solar panel output to “SOLAR” terminal . Skip this if solar panel is not used.
5. Connect battery to "BATTERY” terminal; make sure the positive & negative poles of battery
are connected correctly.
6. Replace the cover, then Shift the brake/release switch on front panel to “ON” position.

_________________
--
turbineZ
--
Wind Turbine Buyer's Guide

Wind Turbine Buyer's Guide
.